The actual device looks like a "bog standard" power resistor with a plate for
mounting on the chassis. Just two terminals. Unless of course it is using
ground through the casing but does not look the type. I can stick the
multimeter on it tonight to check that though.
Alan
-----Original Message-----
From: "spitfires-owner@autox.team.net" <spitfires-owner@autox.team.net> on
behalf of "Donald H Locker" <dhl@chelseamsl.com>
Sent: Fri, 13 Sep 2002 11:36:51 -0400 (EDT)
To: "ralemen@cableone.net" <ralemen@cableone.net>
Cc: "ptegler@cablespeed.com" <ptegler@cablespeed.com>,
"bschwart@postoffice.pacbell.net" <bschwart@postoffice.pacbell.net>,
"spitfires@autox.team.net" <spitfires@autox.team.net>,
"triumphs@autox.team.net" <triumphs@autox.team.net>
Subject: Re: Distributor wiring
Hi, Alan.
The 9.5 ohm value is useful, but are there two at 9.5 each? One 9.5
with a center (or other fraction) tap? Three terminals means two
resistors, in one form or another (or some solid-state active device.)
Still curious
Donald.
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|