On Friday, March 8, 2002 4:29 am, gary durham <gjdurham@juno.com> wrote:
>Alan,
>
>You ARE asking about the size of the crank pulley nut? Go buy a 1&13/16"
> 1/2" drive socket from some place like Farm 'n Fleet. Costs about... I
>don't know, under $10.00 anyway, and is the size you need. Advantage
>there is, if you don't own a 1/2" drive set, then you can just buy the
>socket, by itself, along with a 1/2" breaker bar.
>
>Again, it's one and thirteen-sixteenths of an inch (what an odd
>size!).
I believe it is a Whitworth nut. If my limited knowledge is correct, Whitworth
sizes are a thread specification and the a/f dimensions of the nut are derived
from that.
Whitworth spanners are strange and incompatable with anything other than
whitworth nuts/bolts.
I hope that makes sense.
Dean..
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
|