I reveneered mine for 30 bucks and about 4 hours. Sanded the original down
with 150 grit and a belt sander. Much less on the sandpaper and you'll be
doing it for ever; much more and you'll have no fascia panels left :(.
John
'75 Spit
----- Original Message -----
From: "Richard B Gosling" <Gosling_Richard_B@perkins.com>
To: "spitfires" <spitfires@autox.team.net>
Sent: Thursday, June 15, 2000 6:39 AM
Subject: Dash restoration
>
> What is the best approach to dash restoration?
>
> I am not looking to spend any more money than I can avoid on this - a pot
of
> varnish or whatever, a brush, and a sheet of sandpaper is what I'm aiming
for.
> At the moment the varnish is peeling/cracking at one end (very tempting to
pick
> at it like a scab!), plus a small section is a bit discoloured where a
P.O.
> thought it would be nice to put a strip of dymo tape with the tyre
pressures
> on (how hard are they to remember? Or even look up in the manual?)
>
> My idea is to sand the old varnish off, back to a smooth finish on the
wood,
> then apply a few coats of varnish. Good plan? Should I use a clear
varnish,
> or one with a bit of colour in it (to get a more-or-less stock looking
> finish)? How many coats, how much sanding? What grade sandpaper? Is it
OK
> to use my electric orbital sander, or do I really need to do this the
hard
> way?
>
> Richard and Daffy (once I've done the dash the interior will look great...
if I
> replace the seat covers, arm rest cover, door panels...)
>
|