I had to do that a number of years ago for pretty much the same reason. As I
recall, the thread size is the same as standard plumbing and I just used a
short length of black pipe with a connector to extend the reach and painted it
to match. It would be easy to check by bringing one of the fixtures from the
electrical department to the plumbing department.
Jim
Sent from my iPhone
> On Jun 4, 2024, at 12:40â?¯PM, Steven Trovato <strovato@optonline.net> wrote:
>
> Outside my shop I have a typical flood light with two of these:
>
> https://www.lowes.com/pd/Sigma-Electric-2-25-in-LED-Gray-Switch-Controlled-Floodlight/3136837
>
> Is there any way to extend the part with the threaded end? Through some bad
> planning, one of the lights is blocked by the gutter downspout. I would like
> to extend it out from there. If the wires need to be longer I can figure out
> how to do that. Whatever I do will have to be suitable for outdoor use.
> Moving the downspout would be difficult. I can also relocate the whole
> light, but some sort of extension arm would be the quickest and easiest
> solution of it is possible. Thanks.
>
> -Steve T.
>
>
>
> --
> This email has been checked for viruses by Avast antivirus software.
> www.avast.com
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/shop-talk/1789alpine@gmail.com
>
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/mharc@autox.team.net
|