shop-talk
[Top] [All Lists]

Re: Toilet/Shower drain help.

To: "Lyn Fatt, Brian A" <brian.lynfatt@eds.com>, <shop-talk@autox.team.net>
Subject: Re: Toilet/Shower drain help.
From: "Peter Schauss" <schauss@worldnet.att.net>
Date: Fri, 5 Nov 1999 17:42:05 -0500
Try to tack down the location of the blockage.  Since
the kitchen and bathroom sinks drain properly, they
must feed into your  sewer line downstream from the
spot where the line is blocked.  If you have 
access to the pipes in the basement or crawl space,
you can tell if the pipes are full by taping on them.  Cast
iron pipes will make a sort of dull ringing sound when 
you strike them with your knuckles if they are empty.
If full of water, the pipe will sound full.

If you are lucky, you may have a cleanout plug where
you can get in with a snake.  If not, call a plumber.

HTH
Peter Schauss

----- Original Message ----- 
From: Lyn Fatt, Brian A <brian.lynfatt@eds.com>
To: <shop-talk@autox.team.net>
Sent: Friday, November 05, 1999 12:29 AM
Subject: Toilet/Shower drain help.


> 
> Looking for help with the Toilet and shower drain.
> 
> Symptoms...both toilets in the house drain very
> slowly. The shower backed up this morning when I
> used it, although it is now empty. It was fine
> yesterday. Bathroom and Kitchen sinks seem to drain 
> ok, when pipes are on full blast so the flow out is 
> faster than what the pipes can provide at full blast.  
> The guest shower backs up and caused water to come
> up in the previously empty Master shower. 
> 
> I rented a snake but it wasn't designed for the toilet. 
> It's been spinning in the Master shower drain for a few 
> minutes and has not coughed up anything. I thing there
> is about 3 feet left on the reel. Most of the snake is
> down the drain. Next plan is start pulling the toilets 
> apart so that I can use the snake directly in the 
> toilet drain.
> 
> Anything that I missed? Any other suggestions, or 
> should I call a plumber?
> 
> Brian
> brian.lynfatt@eds.com
> 


<Prev in Thread] Current Thread [Next in Thread>