Dave:
The rear hub nut is not a standard size. You can sometimes get the nut off
with a crescent, but the best thing to do is either buy or borrow the
correct socket.
The size is 1 61/64" Moss does sell the correct socket, so you don't
have to mung up the nut with a chisel like most DPOs have done.
Remember too that the nuts are handed. R/H thread on the Right, and L/H
thread on the left.
Kelvin.
> -----Original Message-----
> From: Dave B. Hammond [mailto:dbh@hamengr.com]
> Sent: Wednesday, April 30, 2003 11:28 AM
> To: MG List
> Subject: Re:mga rear axle
>
>
> I'm trying to undo the nuts holding the hubs on an mga rear axle. A 2"
> socket seemes too big and a 1 7/8" seemes too small. Any
> advice would be
> appreciated.
> Dave
> 1622 mga
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|