> Oh, and while I don't recall any actual interference problems
> at normal prop
> shaft angles, the kicker is that you can't get a grease gun
> on the zerk
> unless it is installed at the correct location -- the cutaway
> is for the
> grease gun tip. So you might test that, too, even if you find
> a shorter
> fitting..
You can also get a fitting for the grease gun that pokes itself inside the
zerk, thus getting around this problem....
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|