| To: | mgs@autox.team.net |
|---|---|
| Subject: | Re: soft top installation |
| From: | PBlstnm@aol.com |
| Date: | Wed, 5 May 1999 10:42:32 EDT |
In a message dated 5/5/99 14:14:56 GMT Daylight Time, vaughme@mail.auburn.edu writes: > For mine the right size pop rivets is 5/32" (4mm) by 1/2" (12mm). > > Same size that I used, though I had to drill the hole out to that size. I had to drill the old rivets out, but then the above size rivets fit without further drilling. Peter |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Saga of the Invalid Trip Permit, Gary R Hacker |
|---|---|
| Next by Date: | Midget Sway Bar Locator Pairs?, and Valve definition, Michael Graziano |
| Previous by Thread: | Re: soft top installation, Edwin Vaughan |
| Next by Thread: | Re: soft top installation, Dan Ray |
| Indexes: | [Date] [Thread] [Top] [All Lists] |