I am planning on doing a very complex engine swap. I am studying installing a
300ZX turbo engine and trans. I have a few connections on getting the parts I
need so this will not be as expensive as it sounds. I will probably limit hp
to 250, I can push the engine to 350hp with a few adjustments, atleast until I
can make the frame of the MG a bit stronger. *Is there any info out there
about the correct places to improve the frame so that it will not twist like
crazy do to the hp.
*Are there any known rear ends that are compatable with the 76 MGB? I think
that with some mods. that a 67 Mustang rear end will be a good upgrade. So I
will also be able to sell the rear end off my MGB. It should not last a week
after the engine swap.
Ron Powell
95 Mazda MX6
76 MGB
|