V8 rubber engine mounts ... again

["Larry Hoy" <larryhoy@prodigy.net>]

Hi all, well it's time to replace my rubber engine mounts.  I'm using
the MG system, the round rubber mounts.  Assuming I put them in right
the first time I may not be needing to ask this question but here goes
anyway.

How are they positioned?  The single stud that sticks out of one side is
not concentric.  Should the stud be in the high position or the low
position?

Larry Hoy

///
///  mgb-v8@autox.team.net mailing list
///  Send admin requests to majordomo@autox.team.net
///  Send list postings to mgb-v8@autox.team.net
///  Edit your replies!  If they include this trailer, they will NOT be sent.
///