mg-t
[Top] [All Lists]

[Mg-t] Oil filter problem

To: <mg-t@autox.team.net>
Subject: [Mg-t] Oil filter problem
From: Mike Eldred <redscirocco@hotmail.com>
Date: Thu, 4 Dec 2008 16:01:11 -0500
Hello all,
This seems so ridiculous I'm almost too embarassed to hit "send," but I
recently changed the oil and filter in my '54 TF 1250, as I've done
successfully a dozen times before, and can't seem to get the filter cover to
seat correctly.  When I start the car, oil comes running out of the filter
assembly.  If I tighten the center bolt, it gushes out.  If I loosen the bolt,
it continues to run out.   I did remove the old rubber ring seal and put in
the appropriate replacement.  Even tried swapping the old one back in.

Anyone have any ideas?

I used a Napa 1300 filter, by the way.  Anyone have trouble with these?  I
have picked up a Wix 51300 in case the problem is the Napa filter.

Thanks for any advice.

Cheers,
-Mike Eldred
-Wilmington, VT


_________________________________________________________________
Send e-mail anywhere. No map, no compass.
http://windowslive.com/Explore/hotmail?ocid=TXT_TAGLM_WL_hotmail_acq_anywhere
_122008
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t

Archives at http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>