mg-t
[Top] [All Lists]

Tach reduction drive

To: "'mg-t net'" <mg-t@autox.team.net>
Subject: Tach reduction drive
From: "drmoyce" <drmoyce@ent-oakland.com>
Date: Tue, 17 Oct 2006 08:38:46 -0700
I had to send my reduction drive for the rev counter out to have the
output shaft re-sleeved so that the gears would mesh.  It came back from
the shop missing parts from the other (generator) side.  The generator
has a hollow shaft with an open groove, like a split at the end, about
1/4" wide by an inch long.  My reduction gear shaft is round, with a
transverse hole just below the tapered tip.  What do I need to engage
the generator shaft?
Andy Moyce
52 TD

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-t

<Prev in Thread] Current Thread [Next in Thread>