Oh, dear, Terry ... it sounds as though yours isn't as long as it should be
.......:<)
Lawrie
----- Original Message -----
From: <TATERRY@aol.com>
To: <grunau.garage@sympatico.ca>; <mg-mmm@autox.team.net>
Sent: Tuesday, March 29, 2005 9:04 AM
Subject: Re: PA-0531 gearbox
> In a message dated 3/29/2005 5:33:41 AM Pacific Standard Time,
> grunau.garage@sympatico.ca writes:
>
>
> > Second question, what is the height of the gear lever above the gate to
the
> > top end of the steel lever? Mine measures 3 3/4". I don't know if some
DPO
> > has shortened the lever or not. Does 3 3/4" appear about right?
> >
> > Third, I think the PA has an octagonal gear lever knob, anybody got a
spare
> > to trade? I have original octagonal knobs for the choke and slow
running. I
> > may use one of these for the gear lever if nothing better comes along.
> >
> >
>
> Bob, my shift lever is 2.75 from the top of the gate to the end of the
shaft
> and the knob for it is much bigger than the choke knob. Barry Walker said
he
> had reproduced these but that probably means that Dowley has them too.
You
> might check with Phil Laiacoma, he might have reproduced them. He did
> reproduce the TA knobs using my original as a pattern. Some of these
knobs were
> black, some brown bakelite....my NA came with brown.
> Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|