Bob, as I understand it, J2 and PA blocks do NOT do well in attempting to
drill larger holes. However, the double breather P blocks are OK. tommm
----- Original Message -----
From: "Robert Grunau" <cgrunau@pathcom.com>
To: "Pat Mullen" <pmullen@telus.net>; <mg-mmm@autox.team.net>
Sent: Tuesday, September 16, 2003 5:33 PM
Subject: RE: MG PB Midget Pistons NEW on EBAY
> I have a new repro J2 block, present bore is under 57 mm. Can I bore this
> block to accept 60 mm pistons safely?
> Or will my PA engine bore to 60 mm safely.
> Thanks for any information, I don't know much about MMM engines ( but
expect
> to learn ).
> Bob Grunau, J-3017, PA-0531
>
> -----Original Message-----
> From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net]On
> Behalf Of Pat Mullen
> Sent: Tuesday, September 16, 2003 1:10 PM
> To: mg-mmm@autox.team.net
> Subject: MG PB Midget Pistons NEW on EBAY
>
>
> Hi all, FYI:
>
> MG PB, Midget Pistons NEW Pre War Item number: 2431803888
>
> 10-day listing
> Ends Sep-18-03 07:49:18 PDT
> History: 1 bid (GBP 29.99 starting bid)
>
> ....Pat Mullen
>
> /// unsubscribe/change address requests to majordomo@autox.team.net or
try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
>
> /// unsubscribe/change address requests to majordomo@autox.team.net or
try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|