I have a new repro J2 block, present bore is under 57 mm. Can I bore this
block to accept 60 mm pistons safely?
Or will my PA engine bore to 60 mm safely.
Thanks for any information, I don't know much about MMM engines ( but expect
to learn ).
Bob Grunau, J-3017, PA-0531
-----Original Message-----
From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net]On
Behalf Of Pat Mullen
Sent: Tuesday, September 16, 2003 1:10 PM
To: mg-mmm@autox.team.net
Subject: MG PB Midget Pistons NEW on EBAY
Hi all, FYI:
MG PB, Midget Pistons NEW Pre War Item number: 2431803888
10-day listing
Ends Sep-18-03 07:49:18 PDT
History: 1 bid (GBP 29.99 starting bid)
....Pat Mullen
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|