In a message dated 5/20/02 12:23:37 Pacific Daylight Time,
lpalmer@roundaboutmanor.com writes:
<< My arms (er, the car's) measure 6-1/8" from the center of the hole at
the radiator end to the very nearest edge (bottom) of the flat which is
against the fender. The part numbers are 2564 (O/S) and 2565 (N/S). Each
bracket has its respective number cast into the arm at the fender end.
>>
Thanks to all for your feedback on this........I have several reference
pictures of NA's and they all have a curved headlight support arm like the
TA/TC and Lew's measurement above is very close to what I have.
So I'm back to thinking I do have the right ones and that there are other
problems causing my wing fit ups......
Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|