Terry,
My arms (er, the car's) measure 6-1/8" from the center of the hole at
the radiator end to the very nearest edge (bottom) of the flat which is
against the fender. The part numbers are 2564 (O/S) and 2565 (N/S). Each
bracket has its respective number cast into the arm at the fender end.
Regards,
Lew
> -----Original Message-----
> From: TATERRY@aol.com [mailto:TATERRY@aol.com]
> Sent: Monday, May 20, 2002 12:38 PM
> To: MIKEFRAN@aol.com; lpalmer@roundaboutmanor.com; deboer@deboer.net
> Cc: mg-mmm@autox.team.net
> Subject: Re: PB Headlight Support Arms
>
> In a message dated 5/20/02 00:04:52 Pacific Daylight Time,
> MIKEFRAN@aol.com
> writes:
>
> << Besides being curved, they would also lack the mounting tabs for
the
> horn.
> >>
>
> Now I'm wondering if I have the correct support arms for my N type. I
had
> convinced myself that I do, but what I have here is identical to the
arms
> on
> my TA. The TA part no. is S46/3 but the N type part number is 3050.
Some
> pls post the P type part number from the factory service parts
list.....
>
> BWalker list the same part number for L/P/K/N and a different one for
> TA/TC.
> This reinforces my thinking that I have the wrong
brackets..........and
> I'm
> having a hell of a time fitting the wings/bracket/radiator to this
beast!
>
> Andrew Fock advises that his HL brackets are same length as mine, so
that
> confuses me further (not hard to do!). Would one of you P type
owners
> post
> the lenght of the your bracket from centerline of the radiator bolt
to
> the
> wing along the bottom of the bracket.
>
> Thanks
> Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|