All i know is bad grounds will make you crazy and the salt seems to kill the
ground wire first in almost every case..
Dave
> -----Original Message-----
> From: Bryan Savage [mailto:b.a.savage@earthlink.net]
> Sent: Wednesday, September 08, 2004 4:47 PM
> To: Dave Dahlgren
> Cc: Sparky; land-speed@autox.team.net
> Subject: Re: Master Switch Help
>
>
>
> Right on, Dave.
>
> I have had some very bad times in years past working on problems that
> were caused by a poor ground(s). I would never add a potential failure
> point in the ground circuit. A bad connection in the +12 circuit is
> much, much easier for me to locate.
>
> Maybe it's just me,
> Bryan
>
> Dave Dahlgren wrote:
>
> >The only con I am aware of is every rotten wire I have seen at Bonneville
> >the worst ones have always been ground wires. The corrosion runs right up
> >under the insulation for the length of the wire. So for me the fewer the
> >breaks in the grounds the better. I am sure some one smarter
> than me could
> >explain why but I am betting it has something to do with the chemical
> >composition of the salt.
> >Dave
|