It should be possible to use a TIG to braze, right? (famous last words)
I've been searching the Internet, and so far have only found a recommendation
that with TIG you
should use a high silicon bronze rod vs. what would be used for gas.
What I want to know is would you use the same flux, and any other concerns. I'm
assuming I'd set the
TIG to negative electrode like with steel, to get a hot surface, but use low
amps.
-Aron-
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|