In a message dated 8/4/03 1:57:19 AM Central Daylight Time,
atravis@spacey.net writes:
<< What I want to know is would you use the same flux, and any other
concerns. I'm assuming I'd set the
TIG to negative electrode like with steel, to get a hot surface, but use low
amps.
>>
Aron I have never brazed with tig but I know the sheet metal workers at the
nuke plant did it all the time. I don't remember them using a flux and yes I
think they were on straight polarity (negative electrode). Larry Mac
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|