Russ;
I wasn't sure just what the correct number was-- you're probably right. I do
know that it was a fabricator's nightmare.
Regards, Neil Tucson, AZ
-----Original Message-----
From: rtmack [mailto:RTMACK@pop3.concentric.net]
Sent: Friday, December 07, 2001 11:02 PM
To: Albaugh, Neil
Cc: 'ardunbill@webtv.net'; land-speed@autox.team.net
Subject: Re: lakester frame
Neil:
"Tipo 61" was referred to as "the Birdcage Maserati". Seem to remember that
they
continued the small-tube space-frame concept through one or two additional
models-- don't know if one was designated "Tipo 63", or not.
Russ Mack
"Albaugh, Neil" wrote:
> Bill;
>
> I'll have to admit that the round- tube chassis that I built was before
the
> invention of "Joint Jiggers"-- it was a hacksaw and a round Nicholsen file
> job-- strictly a manual operation. The thing was built out of 1"OD 0.062"
> and 3/4" OD x 0.049" round mild steel tubing and the tube intersections
were
> a nightmare to cut and to (torch) weld. Halfway through the project, I
> discovered braze welding (nickel-silver-bronze fillet brazing)and that
> solved the welding problems.
>
> The guys who fabricated the Tipo 63 (?) "Birdcage" Maserati chassis must
> have been commited to a lunatic asylum after a few weeks of that work.
>
> I'd still recommend square tubing for a chassis. At least if a round tube
> roll bar is welded to a square tube chassis, the intersection is still a
> straight cut.
>
> Regards, Neil Tucson, AZ
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
/// or go to http://www.team.net/cgi-bin/majorcool
///
///
|