Shawn,
I can't help with the early swivel axles. The swivel axle you mentioned
(BN2 - BJ7) is part number 1B4517. On the two that I looked at there is
a (forging?) number on the lower inboard side, between the two holes for
the steering arm. The number is 1B4518 (off by one).
The inside diameter of the outer bearing is 7/8". On the later swivel
axles (BJ8), the same diameter is 3/4" and there is a left and a right.
The "diameter" that the inboard seal runs on is a separate piece.
Cheers,
Bob Haskell
Austin Healey 3000 BN7/BT7 registrar
On 12/11/20 8:57 AM, S and T Miller wrote:
> I understand that swivel axles are the same from BN2 C.E. 231203 to
> BJ7 (e)21766. Is there a way to identify the swivel axle when apart
> from a car (is there a part # stamped or other distinguishing feature?).
> Thank you, Shawn
>
> The Millers
>
> "Always drive them, but remember each drive in an antique car is a
> test drive."
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/rchaskell@earthlink.net
>
_______________________________________________
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
ox.team.net
|