6 cylinder roadster door? The factory would often put a couple of bends into
the bar going from front remote lever to lock mechanism to take up the bit
you need.
Rich Chrysler
----- Original Message -----
From: "Mark LaPierre" <lapierrem@sbcglobal.net>
To: <healeys@Autox.Team.Net>
Sent: Thursday, August 13, 2009 6:24 PM
Subject: [Healeys] Need A Fix
> My newly installed doors are looking pretty good considering were they
> were 6
> years ago.
> However one door will only open from the outside latch. The inside door
> mechanism needs
> a skosh more pull to release the door latch. Theres only 3 parts here,
> the
> door handle unit,
> the latch unit and the flat bar that connects these 2 units.
>
> I don't see any obvious wear on these parts and there really isn't any
> room
> for adjusting the
> front and rear door mechanisms that I can see. They are secured directly
> to
> the door by machine screws.
>
> Any suggestions on what or where I can adjust to take up the slack.
>
> Thanks Mark
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|