Mark
I had the same problem with one of my doors some years ago. Initially I stuck
a wooden block between the bar and the inside of the door - solved the problem
without having to remove anything. Eventually however, when I had the door
apart, I put a bit of weld in the slot at the end of the bar towards the rear
of the door, effectively shortening the pull. Rich's suggestion is perhaps a
simpler solution.
Rick Swain'59 BN4
> My newly installed doors are looking pretty good considering were they were
6
> years ago.
> However one door will only open from the outside latch. The inside door
> mechanism needs
> a skosh more pull to release the door latch. Theres only 3 parts here,
the
> door handle unit,
> the latch unit and the flat bar that connects these 2 units.
>
> I don't see any obvious wear on these parts and there really isn't any room
> for adjusting the
> front and rear door mechanisms that I can see. They are secured directly
to
> the door by machine screws.
>
> Any suggestions on what or where I can adjust to take up the slack.
>
> Thanks Mark
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as rjswain@hotmail.com
>
> http://www.team.net/archive
_________________________________________________________________
Stay in the loop and chat with friends, right from your inbox!
http://go.microsoft.com/?linkid=9671354
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|