BoB
The easy way is to get the half axle shafts that you have already taken out
and place them backwards so that the domed head is against the hub with the
hub studs going through the holes in the head on the half shafts. Then put
some 3/8 nuts on and tighten, the head of the half shaft will be against the
threaded body of the axle and will pull the hub towards you as you evenly
tighten the nuts, sounds a lot harder than it is. Just do it word for word and
its simple!
The seal and bearing may be the harder bit, make a good note of the seal as it
is in backwards to what you may think, the bearing may be a loose fit, if it
is use some shim steel to set the height and then use a bearing fixing fluid
to lock the bearing in the hub.
regards Andy
_________________________________________________________________
http://clk.atdmt.com/UKM/go/msnnkmgl0010000009ukm/direct/01/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|