The master cylinder on the Hundred is cast iron I believe. Why won't a
gentle honing work? It's always worked for me as long as the cleaning of the
bore was only for minor imperfections.
If the blemishes are severe, sleeving by a professional is the cure.
Rich Chrysler
----- Original Message -----
From: "Alan Schultz" <alan@andysnet.net>
To: "Bluechipracing" <bluechipracing@snet.net>
Cc: <healeys@autox.team.net>
Sent: Thursday, August 10, 2006 10:35 PM
Subject: Re: Bleeding brakes, BN2
> It has been stated many times that honing an aluminum cylinder will not
> work. Is your master cylinder aluminum? It should have a sleeve installed
> then honed.
>
> Alan Schultz
> 67 BJ8
>
>
> Bluechipracing wrote:
>
>>I just rebuilt the master cylinder on my BN2. Honed the bore and installed
>>rebuild kit....all new rubber etc. Now I'm bleeding the brakes, and I
>>can't
>>seem
|