I just discovered some "Nut Remover Sockets" that come in a set for
different sizes made my Craftsman (Sears). I am sure they are available
from other tool manufactures. The one I needed worked great for removing a
rounded off frozen nut. I've seen them for use with a power drill that can
be reversed and a different type that you just use on a normal socket
wrench.
Good Luck,
Ron
----- Original Message -----
>I have run into a problem in disassembling the BJ7 and need some advice
>from
> the list. Five of the ten rear hub nuts have been "rounded off" by
> previous
> workers. The correct size socket just slips when you try and turn it. Any
> suggestions on removing these nuts or am I going to have to drill out the
> studs? TIA. Wendall Cross BJ7.
|