Esko,
I used a thin guage of wire (utility type, not electrical) wrapped
around the trafficator lines to pull the wires back through the stator.
You can pull on wire harder than on string, and as I recall, I did have
to pull pretty hard.
Randy Cooper
>>> "Esko & Megan Cate" <enmcate@comcast.net> 4/5/2004 12:35:35 AM >>>
Is there a trick to pulling the wiring for the turn signal and horn
back
into the stator tube? I pulled a string up through when taking off
the
control head assembly but can't get the wiring to start back down. Is
it
okay/feasible to take off the end wire tips and solder them back on
after
pulling the bare wires? Thanks
Esko
BJ7
|