John,
I did as Peter did. Can't recall the amps but I think it was 10.
Keith Pennell
> I put the fuse between the headlight switch and the two red wires
> which feed the tail lights, front parking lights and the
> dashboard lights.
>
> HTH,
>
> Peter Schauss
> 1980 MGB
> 1963 BJ7
>
> -----Original Message-----
> From: owner-healeys@autox.team.net
> [mailto:owner-healeys@autox.team.net]On Behalf Of John Peak
> Sent: Sunday, April 04, 2004 7:37 PM
> To: healeys@autox.team.net
> Subject: Re: BJ 8 Set-backs - brakes..wiring ... trans conversion
>
>
> --- Jerry Wall <jwbn6@iopener.net> wrote:
> > on your new harness install in line fuse to protect
> > tail lamps and license plate light where the "smoke"
> > will stay in the boot.
>
>
> List,
>
> I would like to do this to my car while I am thinking
> about it. Specifically where is the fuse installed
> and what size fuse should I use? I know this has been
> covered before, but I would rather spend my time
> making the repair than searching the archives in a
> potentially fuitless attempt to get the information.
>
> Many Thanks,
> John
> '59 BN7
|