I have a pair of shafts, bearings and seals (assembled) for sale if anybody
is interested.
On Fri, Jul 13, 2018, 12:04 AM Bill Tobin via Fot <fot at autox.team.net>
wrote:
> Marcel, I just had my diff apart to replace seals and just to look around
> inside. I had to use a 20 ton press to get those bearings off the inner
> axle shaft; very tight. I'd check the tolerances on the shaft and bearing.
> You may have some wear in the parts. Pressing them back together took some
> force too.
>
> Loc tite has a product for holding bearings onto shafts, green I think. It
> may help.
>
> Hope this helps and good luck.
>
> Bill
>
> On 7/12/2018 5:25 PM, van.mulders.marcel--- via Fot wrote:
>
> The inner axle shaft (right side) has moved out of the axle house by as
> much as 12mm, so far that a lot of oil has leaked after a race.
> The ball bearing has slided inwards on the axle shaft by the same amount
> (retained by the oil seal housing). Has anyone experienced this? Before? I
> noticed these bearings had moved a little, but never more than 3mm. In
> fact, nothing does prevent the bearing of sliding on the axle shaft, except
> the interference.
> Does someone know a fix? Loctiting the bearing on the axle shaft?
> Machining a groove for a circlip?
> Marcel.
>
>
> _______________________________________________fot at autox.team.net
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/fot
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/william.tobin31
> at verizon.net
>
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/fot
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/triosan at gmail.com
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20180713/d2c419ce/attachment.html>
|