These stock lifters are larger diameter than triumph. Why would anyone look for
large diameter lifters?
MDunst Headgasket.com 626.358.1616
Fax 626.628.3777
Triple R Munitions, Inc 626.201.9471
T FFL 6,7 SOT 2
On Wednesday, November 15, 2017, Barr, Scott via Fot <fot at autox.team.net>
wrote:
And they've been used in at least one 1296 Spitfire engine, where they're much
larger in diameter than stock.
Scott (B.)
-----Original Message-----
From: Fot [mailto:fot-bounces at autox.team.net] On Behalf Of Tony Drews via Fot
Sent: Tuesday, November 14, 2017 7:59 PM
To: Chuck Arnold and/or Kathleen Kelley <triosan at gmail.com>; Friends <fot at
autox.team.net>
Subject: Re: [Fot] "GT40" lifters
They are commonly used in the TR-2/3/4 block in place of stock lifters by using
a sleeve - in this case they are smaller than stock. If you use the cam
developed by Larry Young you can't use those lifters as he needs the full
diameter of the stock lifter. The Elgin cams work OK with them though.
I'd not heard of using them in a TR-6 until now though.
Regards, Tony
At 01:02 PM 11/14/2017, Chuck Arnold and/or Kathleen Kelley via Fot wrote:
>Somewhere in a Triumph post I read about using what I think were
>referred to as GT40 liofters [tappets].? They are slightly larger in
>diameter than stock TR6 ones.? A set came with my car, but have never
>been used.? Does anyone know of there and the modification [or where I
>might have read about them?].? Also, they are for sale.
>
>Thanks,
>
>Chuck
>_______________________________________________
>fot at autox.team.net
>
>http://www.fot-racing.com
>
>Donate: http://www.team.net/donate.html
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/fot/tony at tonydrews.com
_______________________________________________
fot at autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
_______________________________________________
fot at autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|