Exactly, Glen.
Once again, my camber was set before I installed this adjustable bar. This
would only serve to fine tune if that was important to me. I would not install
this solely to use in adjusting camber.
Larry Young has calculated that it would take .7" of movement at the top of
the tower on each side to effect 4 degrees of camber change.
My final adjustment is relatively small and within a tolerable range,
methinks ...especial if one considers that this has been done successfully in
the
past by sectioning the tube to shorten.
Regards,
Joe
> "People might have differing opinions about this method of camber
> adjustment"
>
> ... well that much I agree with...!
>
> Glen
>
</HTML>
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|