Dewey,
I don't know what the rest of the list will say, but I have a '66 1600 with
at '69 U20. The 1600 and 2000 share a common block casting. The 4-speed
bolted right up to the U20. I am not aware of any special measures which
should be taken to fit a 4-speed to a U20, or a 5-speed to a 1600.
Gary Ault
----- Original Message -----
From: "Dewey Hahlbohm" <hahlbohmd@earthlink.net>
To: "Datsun List" <datsun-roadsters@autox.team.net>
Sent: Wednesday, March 19, 2008 7:49 PM
Subject: [Roadsters] Bell housing front cover question
> Hi all, I am planning to put a 4 speed tranny behind my 2000 engine for
> improved gearing for autocross. I have read you must use the correct bell
> housing front cover, for the tranny you are using, if you swap trannies on
> the 1600 or 2000 engine. Does anyone have the thickness measurements of
> the different front covers for the 4 speed and 5 speed trannies?
>
> I recall reading something about different thickness front covers cause
> increased stresses on the throwout or transmission bearings. Does anyone
> know the specifics about that, or any other reasons for being careful with
> the front covers?
>
> TIA, Dewey Hahlbohm
> ________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as aultgc@att.net
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|