Hmmm-
I remember making a bit of a mess, then calling it quits. But oil didn't try
making a break for it immediately.
The oil that comes up the shaft should just be a trickle- the leakage around
the shaft-
I THINK! It's been a while- can anyone confirm this?
Toby
> When I was rotating the pump I had oil returns from the lower block
> connector that normally fed the distributor. But when I let the drill speed
> up the oil would immediately start rising out of the distributor base hole
> in block. Can a guy just cover the hole w/ a cloth while turning the pump?
> Would this oil normally just fall back in to the oil pan? Otherwise the oil
> will all end up on the floor. Larry.
|