I put my boot over the shims after installing them. Not easy to do but not
impossible. Make sure the shims are fully inserted to each other or else the
boot will not fit.
Mike
----- Original Message -----
From: "Tom Hendricksen" <tom@fransfancies.com>
To: "'Roadsters (E-mail)'" <Datsun-roadsters@autox.team.net>
Sent: Wednesday, August 14, 2002 8:54 PM
Subject: Rear Slave Cylinder Boot Question
> I am trying to install the rear slave cylinders in my 69 2000. The
> shims are no problem because I stacked them in the direction they came
> off and kept them correctly orientated for later reference. The problem
> is the rubber boot that goes behind the backing plate. How do I get it
> over the hand brake arm and then over the cylinder body itself. It did
> not want to stretch that far. If I put it on first I can't get the
> shims to go on.
>
> Tom
> 69 2000
> Portland, Oregon
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|