Rob,
When I had points I had the same problem when using the factory specs and
did as you did. I got fed up and installed a Petronix. I will be installing
a Crane 3000 in the future as it's the uprated model of the cheaper 700
series. With the 3000 you don't need a ballast resistor and can run really
hot coils and get a better burn than either the Petronix or 700.
Mike
BTW - the 3000 is about 150 and the coil.
----- Original Message -----
From: <Robert.Long@CSDInc.com>
To: <datsun-roadsters@autox.team.net>
Sent: Thursday, July 19, 2001 11:50 AM
Subject: Dwell vs Gap
> Dear List,
>
> I was checking out the dwell on my 67.5 1600 last night. It
> seems that with the points gapped to .021", the dwell was around
> 34 degrees. To get the dwell to 50 degrees, the gap was around
> .015". From reading other posts, I should rely on the dwell, not
> the gap, correct? Does this discrepency mean anything?
>
> Thanks again...Robert - 67.5 1600 - ABQ
|