Use a propane/mapp torch to heat those screws up so you don't break them
off. Don't ask me how I know!!!!!! I never met a bolt or screw that resisted
heat.
Mike
----- Original Message -----
From: "Gordon Glasgow" <gsglasgow@home.com>
To: <datsun-roadsters@autox.team.net>
Sent: Tuesday, April 17, 2001 11:52 PM
Subject: RE: Sway Bar Installation
> Usually the biggest challenge is getting the rusty bolts out without
screwing up
> the threads.
>
> Gordon Glasgow
> Renton, WA
>
>
> -----Original Message-----
> From: owner-datsun-roadsters@autox.team.net
> [mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of
> jon_wissler@pngc.com
> Sent: Monday, April 16, 2001 8:01 PM
> To: datsun-roadsters@autox.team.net
> Subject: Sway Bar Installation
>
>
> Yo experts. Neophyte mechanic here. Any suggestions, warnings, or
special
> tricks to installing the 23mm swaybar? It looks like it SHOULD be fairly
> straight forward, but then again, everything LOOKS like it should be
> straight forward. Any advice from gallery would be much appreciated.
> NOWROC top down coming up this weekend, and I was hoping this was an after
> work project that won't keep me up until 3AM. Thanks in advance.
>
> 69 SRL
> NOWROC
> Troutdale, OR
|