Someone else recommended small diameter hose. I use something similar.
Very short lengths of PVC hose sliced in hald and a hold drilled in the
center. Works well, inexpensive and easy to remove without breaking the
prongs.
Ray
68 1600
68 2000
At 06:17 PM 11/08/2000 EST, sidney raper wrote:
>Jason,
>
>They are called "speed nuts" and they are available from just about any
>parts store. The originals were a stamped rectangular contraption that is a
>PITA to remove and usually ends up with at least a few broken pins. My
>suggestion is to get the ones that look like really cheap, cheesy acorn nuts
>that were stamped out of steel. Easier to remove and install imho.
>
>Sid
>
>
>>From: Jason Simpson <jason@xio.com>
>>Reply-To: Jason Simpson <jason@xio.com>
>>To: datsun-roadsters@autox.team.net
>>Subject: Re: Those D A T S U N letters on the hood
>>Date: Wed, 08 Nov 2000 14:18:39 -0800
>>
>>Robert.Long@CSDInc.com wrote:
>> >
>> > Is it possible to get other letters than D A T S U N for the front of
>>the
>> > hood?
>>
>>On a related note, my letters and badges are just sitting in the holes
>>and being held there by some weak friction. What is used to hold them in
>>place?
>>
>> -jrs
>
>_________________________________________________________________________
|