The response to my Alpine Touring inquiry, while much appreciated, has raised
questions in my mind. Here they are is no particular order.
Starters. Does anyone know anything about the gear reduction starters listed
by Victoria British? At $250 they are rather salty, but may be be worth the
price if they solve the starter problem.
Pertronix ignition. Why is it so popular? Is it wiring simplicity? It does
not seem to be made (anymore) to fit the Lucas distributor, and seems to have
a high failure rate. Electronic ignition failures are usually sudden and
catastrophic, and not something that can be jerry rigged to limp home. This
does not sound good. One thing about the old distributors, components are
cheap and can be replaced in a few minutes, even if they require a lot of
attention. How about the Crane Cams FireBall ignition. Is there a problem with
it?
Transmissions and rear axles. In driving about 750,000 miles with manual
transmissions, and over a million miles total, I have lost one transmission
front seal, one back seal, 3 or 4 throwout bearings and clutches and one slush
box. Two axle bearings,one differential bearing (or so the mechanic said)
and a few seals is my rear axle count. I usually buy a new car, and put over
150,000 miles on it before it goes to the crusher. My point is, on an old car
redo, if the gearbox and rear axle are not making strange sounds and are
behaving properly, why bother? I am especially leary of upsetting the
established wear pattern of differential gears if there are no obvious
problems. In my experience, they are extremely durable and when they do fail,
it is a bearing that gives a good bit of notice that all is not well.. Do
people go through them, replacing all bearings? What am I missing here?
Current update: Right now I am leaning toward adding an OD and keeping the
1725, sans Lucas. However, if on teardown, a new block is indicated, out with
the whole drive train!
Thanks to All
Bill
|