Can I re-use the clutch fork after this operation? I plan to cross drill
and pin also...
John
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net] On
Behalf Of Mark J. Bradakis
Sent: Tuesday, February 07, 2006 7:34 PM
To: 'Triumph 6 Pack'
Subject: Re: Broken Clutch fork pin
The most common method is to drill a hole, maybe 1/8 inch or so, in the fork
above the pin and drive out the broken end with a "suitable drift" from
above.
Hmm, another procedure that could use some photos to elaborate.
mjb.
|