And when you drill the rear holes, don't lean too hard on the drill,
it will come through clean through and leave a nice exit hole facing
the ground. The hollow space between the top and bottom of the lid is
not much before you "break on through to the other side" !
Trust me.
Craig
>Mike,
>
>Funny you should bring this up. I just re-installed mine. Assuming we're
>talking about the same one. I've seen 2 styles. The type that's assembled
>and the type that's one piece. Mine is one piece. The front holes went all
>the way through the trunk lid...accessible from top & bottom. The rear went
>only through the top side. Of course the holes on my trunk lid became way
>too big so I was forced to make them even bigger & use the smallest toggle
>bolts that I could find. DON'T LET THIS HAPPEN TO YOU!
>
>Good luck,
>
>Todd
|