| To: | ngwehmeyer@attbi.com (Neil Wehmeyer) |
|---|---|
| Subject: | Re: Machining head for compression ratio |
| From: | tr6taylor@webtv.net (Sally or Dick Taylor) |
| Date: | Sat, 1 Feb 2003 16:44:22 -0800 (PST) |
Neil---If all you want to do it "get close" to the target 9.5:1 CR, mill the head to 3.400. If the block has been decked, (not likely, if the head is stock) then the CR will be possibly .2 higher. In a separate message sent you, is the formula for figuring all of this, by the numbers. Dick |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | manifold gaskets, Lizirbydavis |
|---|---|
| Next by Date: | Re: manifold gaskets, Timothy Holbrook |
| Previous by Thread: | RE: Machining head for compression ratio, Hugh Barber |
| Next by Thread: | Re: Machining head for compression ratio, Don Malling |
| Indexes: | [Date] [Thread] [Top] [All Lists] |