[TR] TR6 front camber shims

[lee at automate-it.com]

Thanks all,

I just used my spring compressor to relieve spring tension then the 
entire suspension assembly could be shifted, and I was able to remove 
the shims.

Lee

On 2025-11-10 06:43, Randy and Valerie DeRuiter wrote:
> Lee-
> 
> After you loosen the wishbone brackets try a small pry bar between the 
> lower spring plate and the frame- that should take the pressure off the 
> shims and let you add or remove.
> 
> Randy
> Sent from my iPad
> 
>> On Nov 9, 2025, at 10:10 PM, lee at automate-it.com wrote:
>> 
>> I’m adjusting front camber. The official method is “slacken the nuts 
>> securing lower wishbone brackets“ and “remove or add shims as 
>> necessary”.
>> 
>> Without removing anything other than the wheel, there’s only tight 
>> access, and I can’t get the shims to budge. Any suggestions?
>> 
>> Thanks,
>> Lee