[TR] How do i get this off?

[J.C. Hassall]

An Army combat engineer friend used to say that there was no problem which
an application of high explosive couldn't solve.

If you can tilt the block vertically (not critical but helpful), try
applying heat to the crank nose/pulley ID, then hold a candle on it.  The
melted paraffin will wick around the bits, which should make removal
somewhat easier.  It may take a couple of attempts.

Good luck

jim

On Sat, Dec 16, 2023 at 10:27 AM dave northrup <dave at ranteer.com> wrote:

> Trying to extract the crank from this block.  It's obviously been sitting
> for a few years.   How do i get the pulley etc off?
> ** triumphs at autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs
> http://www.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/jhassall@gmail.com
>


-- 
jim  W4BEA
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20231216/6e86ba46/attachment.htm>