[TR] TR3 Engine Rear Seal

baltoalpine at gmail.com baltoalpine at gmail.com
Sat Dec 2 09:08:47 MST 2023


Hi guys,

 

I know this has been discussed in the past but I'm stuck. I have the engine
out and on a stand, upside down for good access. I got the no-machining seal
from Moss and have the seal on, spring in place, and split oriented towards
the top of the engine, but every time I try to set the crank back into the
bearings the seal bunches up at the rear bearing cap joint.  I had the end
cap on, but not tight. I plan to remove the end cap, clean up the Permatex,
and try without the cap, hoping I can get the seal into place.

 

Am I missing something here?

 

Joe 

'57 TR3

'75 Spit (needs engine rebuild)

'58 MGA (in long term resto)

'67 Alpine (the driver)

'53 Sunbeam -Talbot (just back from engine rebuild)

'54 Sunbeam - Talbot (quietly awaiting attention)

'60 Hillman Minx (source of much frustration)

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20231202/8ce5eefc/attachment.htm>


More information about the Triumphs mailing list