[TR] Wheel bearing races

[Allen Hess]

TR hub does have notches at 180 degrees for driving out the bearing races. 

Allen 

> On Feb 26, 2021, at 8:52 PM, Tony Drews <tony at tonydrews.com> wrote:
> 
> The "how to get them out" posts seem to be spot on.  A tip for driving the new ones in - you can use the bench grinder on your old races to make them slightly smaller diameter and use them (with other suitable implements of destruction) to drive the new ones in.
> 
> On driving them out - many hubs have a little cutout in a couple of spots to give you better access to the back side of the race. Not sure about the TR hub, but clean all the grease out and look for those.
> 
> Cheers, Tony Drews
> 
>> On 2/26/2021 4:59 PM, Jim Henningsen wrote:
>> Ok, haven’t changed these out by myself before and want to learn to do it correctly.  Redoing front suspension on myTR4a.  Looking for recommendations on removing the front wheel bearing races so I don’t damage the hub.  Same as a Tr6.  Thought I’d ask our experts since I didn’t see a triumph post on YouTube and I don’t always trust YouTube.
>> Jim Henningsen
>> Ocala, fl
>> 61 3
>> 62 4
>> 67 4a
>> 75 6
>> 81 8
>> 
>> ** triumphs at autox.team.net **
>> 
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/pipermail/triumphs  http://www.team.net/archive
>> 
>> Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/tony@tonydrews.com
>