[TR] Stag, TR6, GT6 Stromberg Carbs

[DAVID MASSEY]

 Check the face of the carb where it bolts up to the insulator.  Is there a small port in the approximate area where you find the slot in the old insulator?  I believe it is for the over-run valve and perhaps one of the other control devices bolted on the side of the carb.  Those may not work properly without the slot.
 
Dave 

 
 
-----Original Message-----
From: Frank Magnusson <fmags at cox.net>
To: triumphs at autox.team.net
Sent: Sat, Aug 7, 2021 9:37 am
Subject: [TR] Stag, TR6, GT6 Stromberg Carbs

Carb insulators.  Just pulled my carbs off the intake Y adapter on my Stag to replace the insulators/gaskets which were leaking and have a question.  The original insulators have a slot on one side that mates to what appears to be a passage on the carb face (the side with the 4 attachment bolts).  BUT the new insulators and gaskets from Rimmers do not have this slot at all.  Wondering what the purpose of the slot is and if I need to have the insulators machined to have a slot cut into them or if they are ok to install as is without the slot.  ROM mentions to align the insulator with the slot as does TR6 guidance.  Stromberg overhaul manual doesn't even mention it.

Sent from my iPad
** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs  http://www.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/dave1massey@cs.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20210807/c33d8284/attachment.htm>