[TR] How to tell the size of bolt or setscrew from the part number?
bill beecher
notakitcar at yahoo.com
Wed Jun 17 13:21:30 MDT 2020
Taking a calculated risk here:
This shows up in the TRF catalogue as a set screw(fully threaded) 3/8”x1-1/4”, fine thread. You thoughts on the numbers looks to be right, 3/8”=9.5mm; the 10 would be the number of 1/8” increments.
Bill
Serenity Now......
On Jun 17, 2020, at 1:45 PM, Sujit Roy <triumphstag at gmail.com> wrote:
I've been trying to figure this out, but am at a loss. Please help
I have a part number in my parts book. I also have the standard Triumph parts list.
HU910
HU is set screw and I'm assuming is fully threaded.
HB on the other hand is a bolt and has a shoulder
I'm assuming the 9 is the bolt diameter. Am I on the right track?
What is the 1 and 0 and can I tell from it, if it is a NC or NF thread?
I'm aware later Triumph switched the part no. system and that system is more confusing.
Regards, Sujit
--
Sujit Roy
Cupertino, California
https://triumphstagblog.wordpress.com/
** triumphs at autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/notakitcar@yahoo.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20200617/b768042d/attachment.htm>
More information about the Triumphs
mailing list