[TR] slightly higher sitting nut?

[Rye Livingston]

According to the Haynes Workshop Manual, the Rocker Pedestal torque setting is 24-26lbs.



On Sep 25, 2018, at 08:03 AM, Paul Dorsey <dorpaul1 at gmail.com> wrote:

Thanks!What do you think the torque value might be?
Thanks, Paul

On Mon, Sep 24, 2018 at 10:13 PM Wbeech at flash.net <wbeech at flash.net> wrote:
No worries.  As long as all four are equally tight/torqued you’re OK.  Quite possibly that stud is longer or just not threaded as far into the head. 
Bill

Sent from my Handspring Treo

On Sep 24, 2018, at 7:38 PM, Paul Dorsey <dorpaul1 at gmail.com> wrote:

It doesn't really bother me, but I've noticed something odd about my engine;  Of course there are four 9/16" nuts holding the rocker arm to the head.  Initially all 4 nuts were tight, however, nut #4 (rear nut) was two or three threads higher on it's stud.  It's okay that it's higher, right?  In time, I intend on finding the torque value for all four nuts.  Is this listed in the workshop manual?

Thanks, Paul Dorsey
** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/wbeech@flash.net

** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/ryel@mac.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20180925/fc9590a6/attachment.html>