[TR] Setting valves Procedure

[Rye Livingston]

Paul,

The instructions in the manual are easier to follow, but yeah, pretty much the same.  I went into my garage and snapped a photo of the instructions in the Haynes Manual that I follow.

Rye


On Sep 18, 2018, at 07:53 PM, Paul Dorsey <dorpaul1 at gmail.com> wrote:

RYE, is your method of adjusting valves consistent with Alex’s? I suspect they are the same

On Tue, Sep 18, 2018 at 8:56 PM Alex & Janet Thomson <aljlthomson at charter.net> wrote:
Except for small, air-cooled engines that may have an automatic compression release mechanism built into the cam shaft (either in the cam grind or as a centrifugal device), I always taught my shop students that you can never go wrong by bringing each cylinder up to TDC-compression and then adjust the valves for that cylinder. There are often a variety of short-cuts where a manufacturer will tell you to adjust certain valves at TDC - Compression of #1 cylinder and then the rest of them at TDC – Exhaust #1 cylinder but those are engine specific. Most 4 cylinder engines have a firing order of 1-3-4-2, so if you see “valve rock” (exhaust closing, intake opening) on # 1 cylinder, you know that #4 is at TDC – compression and its valves can be adjusted. Then, turn the crankshaft a half turn ( total number of cylinders divided by 2), and adjust the next cylinder in the firing order which would be #2. Then 1. Then 3.  Distributor rotor position on a gas engine will help you figure out who is at TDC – compression. Diesels don’t have that option, other than pump timing marks for #1 cylinder. Look in your shop manual for details.
 
Alex Thomson
 
From: Triumphs [mailto:triumphs-bounces at autox.team.net] On Behalf Of Paul Dorsey
Sent: Tuesday, September 18, 2018 6:33 PM
To: Triumph list Team.net
Subject: [TR] Setting valves Procedure
 
 Is there a universally excepted method by which to  adjust the  valves for A  TR three? I know when I asked about this  before that Randall sent me a link to a bunch of articles but I don’t think any of them  concern setting The valves.  Where can I learn to do this?
 
Thanks, Paul Dorsey TR three 1960
** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/ryel@mac.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20180919/d9775b12/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: ValveAdjustmentSteps.jpg
Type: image/jpeg
Size: 330327 bytes
Desc: not available
URL: <http://autox.team.net/pipermail/triumphs/attachments/20180919/d9775b12/attachment.jpg>